Our ruler is designed so the user can cut 45 degrees, 60 degrees or straight lines. Each edge is marked for the degree it can cut. The ruler is 6 wide by 23 on the long side of the ruler with a hang hole on either end.
The ruler is marked for cutting on the 45 degree at , , , and 1 etc. The light etched lines are the , the dotted lines are the , and the mark bold lines are the inch lines. The 60 degree edge and straight edge are setup the same way.
Slip Stop is enclosed for non-slip cutting and may be cut into 3 length wise strips. Peel off paper and place diagonally on ruler as desired. Dont let the slip stop go over the edge of the ruler as it will dull your rotary blade.